Installation Guide



   
Registering the terminal for service  
   
How can I setup service for Hughesnet?
After the Dish is setup based on the setup manual specification. You would move to the Computer and follow step by step.
  1. Open a web browser on the computer connected to the terminal.

  2. Access the terminal's System Control Center, by typing 192.168.0.1 in the browser's address or location bar and pressing Enter. If the System Control Center does not appear, make sure the web browser is not configured to connect through a proxy server.

  3. Scroll down and click Start Registration on the System Control Center home page to access the Registration screen.

  4. Enter the 28-digit registration ID you received when you purchased your upgrade in the Registration ID fields. Enter the registration ID exactly as it appears in the confirmation e-mail The registration ID fields are case-sensitive and do not recognize the letter o/O, only the number zero (0).
    Note: As a reminder, your registration ID was provided in the confirmation e-mail you received after purchasing your upgrade. Alternately, it is available by contacting our HughesNet support hotline at 866-347-3292.

  5. Click Next.

  6. Enter your zip code on the Antenna Location screen. Click Next. Do not select the Enter location manually check box.

  7. Verify the city and state for the zip code is correct on the Verification of Antenna Location screen shown. Once verified, click Next. If the information is incorrect, click the Back button and enter the correct ZIP code.

  8. Registration status messages are displayed on the Registration in Progress screen. Click Next when prompted to do so.

  9. Click OK on the pop-up that appears, to access the registration server.

  10. Click I Agree on the Subscriber Agreement form that appears to accept the subscriber agreement. If you see a Security Warning Alert click on Yes to continue/bypass.

  11. Refer to your confirmation e-mail and enter your site account number (SAN) and personal identification number (PIN) on the Registration screen.  If you cannot locate your SAN and PIN e-mail, contact HugheNet customer support at 866-347-3292.

  12. Click Continue.

  13. Click Swap, on the Registration screen.

  14. Print the page that appears on the Registration screen or record the information in the Quick Start Guide that was shipped with the HN7000S terminal. Click Continue.

  15. The HN7000S terminal downloads its configuration parameters from the Network Operations Center (NOC).

  16. Click Restart, on the Registration Complete screen, to restart the HN7000S terminal.

  17. Click Close on the Terminal Reset screen. The HN7000S terminal is now registered for service.